- This topic has 0 replies, 1 voice, and was last updated 13 years, 5 months ago by .
Viewing 1 post (of 1 total)
-
Posts
-
Question: I am going to attempt to build the straight bar. I have changed the measurements to make it only 54″ long instead of 8 feet. I want to build a shelf in the inside of the unit about midway up. What extra steps do I need to do?
Answer: Once you have framed the bar up, just measure the inside width and length. Cut a 1/2″ piece of plywood and two 2×4 end support pieces the same width as you self. Afix the two supports to either end about midway up. Lay the shelf sheet on top of the end supports.
TIP: if there is any sag in the shelf, you can simply add a middle support frame or add a lower 2×4 support the length of the shelf to make it “stiffer”.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.