- This topic has 1 reply, 2 voices, and was last updated 12 years, 2 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
i am building this bar but on the cut list it stops at # 83… in the plans it has items numbered from 84-101… where can i get a cut list for these?
Those are all trim & sheeting and should be directly measured against your current work. The widest sheets should be 48″, run grain vertically or however you prefer.
I’ll check into the CHBD to see if a few of those parts could be added, but the bottom line is to just work off the assembly diagram. Hope that helps.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.