- This topic has 0 replies, 1 voice, and was last updated 11 years ago by .
Viewing 1 post (of 1 total)
-
Posts
-
So have this bar built…and now I have to FINISH the front.
I have minimal tools, so that is part of my issue. My plans was to put OAK Plywood up as the front, and then stain, etc.
However, how do I “TRIM” the “front corners” and make them look nice. I am sure if I had a fancy table saw it could do it, but all I have is basic hand tools.
Is there any special way to do this easily.
Hope this makes sense.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.