- This topic has 1 reply, 2 voices, and was last updated 7 years, 9 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I am building the EHBP-03 Straight Kegger, and have downsized it to 84.5L x 25W. When CHBD recalculates item 41 (side panels) it leaves width at 22″. This appears wrong. I am reducing the width by 4 inches, therefore the width of the side panel must decrease. A 22″ side panel clearly does not fit. Can anybody help with this?
The CHBD is more for framing….so if you run across a sheeting error, just pull out the tape measure and adjust as needed. I have found it’s not perfect and has some strange output when making things smaller…that being parts that go to zero size….but, if that happens, it means you went so small that the part is no longer required.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.