- This topic has 0 replies, 1 voice, and was last updated 14 years ago by .
Viewing 1 post (of 1 total)
-
Posts
-
When you see odd measurements, it is simply that the part was entered exactly as shown in my CAD program. Parts with oddball measurements are most likely angled or mitered boards. In all cases of mitered boards, the measurement is on the LONGEST edge. It is recommended that you get out a tape measure and physically verify all mitered cuts against your existing work before you make them.
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.