- This topic has 1 reply, 2 voices, and was last updated 13 years, 4 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
I am using the CHBD to modify the standard L shaped plan into a 46 X 80 layout. When I go into the first section and modify the length, I match lengths and save the section. Then I go to the other section and do my change, match and save. However, if I open the first section again it gives me a warning to match lengths. This can be repeated indefinitely…
I don’t have any confidence in my cut lengths and bill of material with this going on. Any ideas???
PLEASE – DO NOT USE THE MATCH BUTTONS!
This is stated in the User Guide https://www.barplan.com/chbd/designer/user/manual/
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.