- This topic has 1 reply, 2 voices, and was last updated 10 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Is there any way that you could work some plans up for a tall Pub Table? I have attached a pic to give you an idea.
[attachment=104]ArtsCraftsPubTable.jpg[/attachment]
Thanks
looks simple enough…I’ll see what I can do. Toughest part would be the center notch cut (halved joint) for the cross supports and the apparent mortis and tenon when they meet the legs. Could use dowels for the mortis & tenon or even a pocket hole from below.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.