Rounded Corner for L-Kegger Bar

[Anonymous]

I’d like to make the corner of the L-Kegger bar rounded. I can probably handle the framing adjustments (although plans to do so would be great also, if you’re up to it, Steve!), but my biggest dilema is finding a rounded arm rest rail. I was planning on adding an arm rest rail anyway instead of just having the arm rest be flat as in the plans and the finishing tips has the arm rest I have in mind in straight lengths only. Any suggestions?
Thanks,

[Anonymous]

Nobody’s tried any rounded wood-working, eh?

[Anonymous]

This may be too late (unless you’re like me and are in long term planning mode) but I have found several sites online which carry different radius mouldings. I have to warn you, they ain’t cheap. If you decide to go this route you’d probably be best to get all your mould from the same source so the profile matches. Also, the framing should be pretty straight forward (no pun intended) compared to making the curved panel to go around the curved section. I’d suggest making sure you have all those details worked out and maybe even build a mock up before shelling out for the curved moulding.

http://www.curvedmouldings.com/images/p … r_rail.gif

http://www.tapeease.com/bar_rails_and_splices.htm

[Author]

Posts