- This topic has 1 reply, 2 voices, and was last updated 10 years, 10 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hi. Because of space limitations I have decided to do section B only. My question is for the bar top assembly base layer. The cut list says #74 is 39.6×39.6″ is that correct? I cut that and the piece sticks out way too much (39.6″ funnily
). I know there needs to be the mitre cuts, but we are only looking for a 6″ overhang, correct? Also, If I’m only doing B section what sizes should 73 and 75 be?
Many ThanksYour raw measurements are correct. Here’s some more detail on cutting the angles.
Please note: If doing just the B section, cut 73 & 75 about 3 or 4 inches longer than show then trim back to your desired overhang depth.
Attachments:
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.