- This topic has 1 reply, 2 voices, and was last updated 14 years, 2 months ago by .
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
Hey folks,
I will soon be ready to pour Envirotex for my bar top, and I am curious on opinions for the thickness of the pour. Does thicker look better, 1/4″ vs. 1/8″? What thickness have you all poured your tops? I realize multiple pours will probably be needed, is it better to make several thin pours instead of a few thicker pours? Any opinions are welcome.
Thanks,
JimI did a surface coat and then the flood for a shuffleboard table. I have an 1/4 thick surface and love the look. I plan the same for the bar top with beer coaster inlays. It came out perfect, not a wave, ripple, or low area.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.