[pierrot_]

Sam,

Thanks for the info, after further looking into the drawing I seen that and had to do some subtraction. So am I correct that the finished wood for the front panels gets mounted underneath the 2×4? also has anyone not used the 2×4 and went with the 3/4 wood of their choice and just screwed the 2×8 insto the top of that so that the front is all flush? I just went to local place that sell pool tables and bars, and looks like thier entire bars are made up of 3/4 wood with vaneer laminate. Not sure how stable this would be. I know with the 2×4 plans that someone could stand on my bar (dont plan on that happening but you never know how drunk woman can get).

Thanks again,
Dan

[pierrot_]

No thanks, I have started the build and made some adjustments to section 1 ( going to be alot smaller) now with the front panels I am seeing the measurements are different for all the pieces 60,61,62,63,64? Shouldnt all pieces be the same heigth? also on the keg side I can get away with using 1 sheet of 4×8 since corner to corner in under 96 inches. and the other side is shorter. Now from looking at pictures the wood is going to go under the 2×4 correct? also I am going with the arm rest option is there any plans for the top listed? I also noticed on the plans for the bar top item 41a 41b and 42 are different sizes. looking at 41b the 29 is right, however looking at 41a, looks like its smaller than the 29″ that is listed? Is there updated documentation that I am missing?

I must say for the most part this has been pretty simple, and the bar is sturdy compared to the American Heritage bars I was looking to purchase for $4200. I have about $500. in wood (Maple) so this was a great investment, and site has been nice to get some ideas. If you can point me to the right direction for the top with putting in armrest that would be great, also let me know about the front pieces, I am hopeing that the 2×4’s up front won’t be showing.

Thanks,
Dan

[Author]

Posts